This sensor is used to measure coolant temperature. Use caution when changing sensor and lubricate o-ring. This sensor is also used in the older D7W model 25.1666.01
The series resistor is used in the 24 volt D7W model 25.1667.01 heater
This glow plug screen is modified to help reduce carbon build up. It should be changed when you change the glow plug
This control unit is used on the 25.1807.05 - D7W - 12V heater only. It will not work with the older 25.1666.01 models
This flame sensor is used with the D7W coolant heater model 25.1807.05. It will not work with the 15.1666 models
This seal is used between the heat exchanger casing and the thermal safety cut out switch (overheat switch) on the D7W.
This temperature sensor threads into the outer casing of the heater and monitors coolant temp. Use caution when removing. Sometimes sensor is difficult to remove.
This resetable overheat switch is used in the 25.1807.05 model D7W heaters. It will not work in the 25.1666.01 models. This switch is also reffered to as the safety thermal cut out switch.
This glow plug is used in the D1LC thru D8LC 12 volt heaters. It is also used the in late model D5W (25.1732.05)and D7W (25.1807.05) 12 volt heaters
Displaying 1 to 9 (of 9 products)
