12 volt combustion blower motor for Espar Airtronic D2 heater. This blower motor is for 12 volt heaters only. Don't forget to order the blower motor gasket.
gasket, combustion blower gasket. This gasket should be replaced anytime the heater is disassembled
This glow pin is used in heater models 25.2069.05 / 25.2113.05 / 20.1822.05. This glow pin works in 12 volt units only.
This combustion burner tube can get carbonized after several years of use. It is sometimes difficult to cleanand needs to be replaced. The new combustion burner also comes with the thermal insulator.
This thermal insulator is used between the burner and the heat exchanger. This insulator should replaced anytime the heater is diassembled
this overheat sensor/flame sensor monitors heater start up and temperature of heat exchanger. This part is also refered to as the combi-sensor.Check repair manual for resistance values
This tool is an easy way to remove the glow pin without having to completely disassemble the heater. Practically a necessity in performing regular PM on you Espar D2 or D4 airtronic
This heat exchanger is used for the D2 heater. Always replace thermal insulator and blower motor gasket when reassembling heater
This fillister head bolt is used to secure the burner tube to the heat exchanger. Three bolts are required. They are sold in a package of 3.
This flange seal completes the seal between the heater and the mounting surface.
Displaying 1 to 10 (of 14 products)