This safety screen fits the B3LCC, the D3LCC , D3LC and D3L inlet. This safety screen is necessary if return ducting is not used to protect occupants and fan motor
This current regulator is used on the D3L model to regulate current to glow plug
This control unit is used on the D3L model 25 1483 05 - 24V heater
This external sensor is used for remote temperature monitoring
This fuel metering pump is used on all D3L - 12 volt heaters
This felt ring is used between the combustion blower and the heater exchanger on a D3L heater. Two (2) of these rings are required
This liner is used on all D3L models. This liner aids in atomization fo the fuel/air mixture. This liner should be replaced any time the heater is disassembled for cleaning.
This hood is used on all D3L models. It does not fit on the D3LC and D3LCC models
This seal ring is used to seal the glow plug ventilation hole where the combustion blower and heat exchanger meet
This safety thermal cut out switch is also reffered to as the over heat switch. This is a resetable switch. Always order new clips p/n 171.42.080
Displaying 1 to 10 (of 10 products)
