Espar D5L

Glow plug screen

This glow plug screen is used on the D1LC and D1LCC heaters - diesel only

• Also listed in:
• Espar D5LC
• Espar D1LC
• Espar D1LCC
• Espar D5L

Blower motor seal

This seal is used between the blower motor and heat exchanger on heater model B5L/D5L/B5LC/D5LC

• Also listed in:
• Espar D5LC
• Espar B5L
• Espar B5LC
• Espar D5L

Printed circuit board

This printed circuit board is used on the B5L/B5LC/D5L and D5LC - 12 volt heaters

• Also listed in:
• Espar D5LC
• Espar B5L
• Espar B5LC
• Espar D5L

Hood - rear

This is a 90mm hood for use on all B/D5L and B/D5LC heater

Blower cover seal

This blower cover seal has a tendency to crack. Always replace when reassembling the heaterThis seal is used on all the 5KW air heaters B/D5L-Airtronic 5 series

Blower cover

This cover seals the blower motor from the heat exchanger. Always change blower cover seal 25.1729.06.0001 when reassembling the heater

Heat exchanger seal

This heat exchanger seal should be replaced anytime the heater is diassembled and cleaned. Also order blower cover seal 25.1729.06.0001

• Also listed in:
• Espar D5LC
• Espar Airtronic D5
• Espar B5L
• Espar B5LC
• Espar D5L
• Espar Airtronic B5

Blower seal ring

This blower seal ring seals the blower motor casing to the blower motor housing.

• Also listed in:
• Espar D5LC
• Espar Airtronic D5
• Espar B5L
• Espar B5LC
• Espar D5L
• Espar Airtronic B5

Temperature sensor

This temp sensor is mounted on the heat exchanger closeset to the glow plug. This temp sensor has a blue wire harness. It fits all B5L/D5L/B5LC and D5LC heaters, but DOES NOT fit the Airtronic series heaters

• Also listed in:
• Espar D5LC
• Espar B5L
• Espar B5LC
• Espar D5L

Safety thermal cutout switch

Also known as the overheat switch, this switch shuts off the fuel metering pump and allows the heater to cool down in the case of an overheating situation. Example - restricted ducting, inlet or discharge.

• Also listed in:
• Espar D5LC
• Espar B5L
• Espar B5LC
• Espar D5L